Thanks for your response, Leen. I went to a working machine, opened up the autoinstall configuration utility, and used it to create the partitions I wanted. Then I saved that file, and sucked everything between <partition> and </partition> (inclusive) into my existing control file (just after the </general>). Then I tried the install again. I still got an "ERROR: No proposal". Below is the code generated by the autoinstallation config utility. Anyone see any problems? Thanks!
On Tuesday 22 June 2004 23:21, David Corlette wrote:
Here's the relevant section of my control file: <partitioning config:type="list"> <drive> <device>/dev/hda</device> <use>all</use> </drive> </partitioning>
Try to create this setup with the autoyast module, and see if that works.
<partitioning config:type="list">
<drive>
<device>/dev/hda</device>
<initialize config:type="boolean">true</initialize>
<partitions config:type="list">
<partition>
<crypt>twofish256</crypt>
<filesystem config:type="symbol">reiser</filesystem>
<format config:type="boolean">true</format>