Hello folks, I have a trouble to start the autoinstall process of SuSE Linux 9.1 over the LAN. In my grub.conf on the boot floppy I have the following entries: title SuSE Linux 9.1 Installation kernel (nd)/boot/suse-linux-9.1 insmod=e100 install=ftp://10.73.59.88/pub/suse/i386/9.1 initrd (nd)/boot/suse-linux-9.1.initrd title SuSE Linux 9.0 Installation kernel (nd)/boot/suse-linux-9.0 insmod=e100 install=ftp://10.73.59.88/pub/suse/i386/9.0 initrd (nd)/boot/suse-linux-9.0.initrd The installation comes up to the point, where the installation process loads some data (53308 kb) onto the ram disk. It draws dots and switches then in the ncurses mode with the following error: "Your computer doesn't have enough memory to run YaST. To continue, activate some swap space" Some last lines on the tty3: ... going for automatic install Loading image "/pub/suse/i386/9.1/boot/root"... cramfs "root 53308" image size: 53308 kB mount: /dev/ram2: we need a loop device mount: using /dev/loop0 Loading image "/pub/suse/i386/9.1/driverupdate"... ramdisk /dev/ram3 freed Ther is not the file driverupdate in the root dir and in the subdirecories of the distribution ! The installation over pxe + grub over the LAN failes with the same error. Here is a section of my grub.conf for pxe-boots: # SuSE Linux 9.1 Installation title SuSE Linux 9.1 Installation root (nd) kernel /boot/suse-linux-9.1 ramdisk_size=65536 insmod=e100 install=ftp://10.73.59.88/pub/suse/i386/9.1 initrd /boot/suse-linux-9.1.initrd # SuSE Linux 9.0 Installation title SuSE Linux 9.0 Installation root (nd) kernel /boot/suse-linux-9.0 ramdisk_size=65536 insmod=e100 install=ftp://10.73.59.88/pub/suse/i386/9.0 initrd /boot/suse-linux-9.0.initrd The installation of SuSE 9.0 works fine, it doesn't matter, whether over pxe + grub or with grub boot floppy. My PC has the following hardware configuration: - Intel P-III 550 MHz - 128 MB RAM - 9 GB SCSI HDD - Matrox G400 AGP card - Intel EtherExpress 10/100 NIC Any help will be appreciated ! Thank you very much ! Regards, Hermann Maurer