Re: [suse-autoinstall] SuSE 9.1 failed Setting up network after network-installation

5 May 2004


      I haven't used 9.1 yet, but when network problems have come up in 9.0 
just going into yast2 and either editing the card entry to be eth0 or 
delete and readd the card under eth0.


Mike

On Wed, 5 May 2004, Hoepfner, Enrico wrote:
...
Date: Wed, 05 May 2004 16:44:49 +0200
From: "Hoepfner, Enrico" 
To: suse-autoinstall@suse.com
Subject: [suse-autoinstall] SuSE 9.1 failed Setting up network after
    network-installation
Hallo,
i have installed SuSE 9.1 with autoyast successfully - nearly :-)
After a complete installation over network, SuSE "failed Setting up network".
lsmod show the right module for network-card (for example: 3c59x)
   ifconfig show only lo0 and sit0
the network-part of autoyast-config (which was ok for SuSE 9.0) is
<networking>
       <dns>
         true
         true
         <domain></domain>
         <hostname></hostname>
         <nameservers config:type="list"/>
         <searchlist config:type="list"/>
       </dns>
       <interfaces config:type="list">
         <interface>
           <bootproto>dhcp</bootproto>
           <device>eth0</device>
           <startmode>onboot</startmode>
           <wireless>no</wireless>
         </interface>
       </interfaces>
       <modules config:type="list">
         
           <device>eth0</device>
         
       </modules>
       <routing>
         false
         <routes config:type="list"/>
       </routing>
     </networking>
can anyone help please
thanks and best regards
    enrico

Re: [suse-autoinstall] SuSE 9.1 failed Setting up network after network-installation

mbrown