On Wed 15 Feb 2017 06:21:25 PM CST, Malcolm wrote:
On Thu 16 Feb 2017 12:19:15 AM CST, Alexander Bergmann wrote:
Hi everyone,
I've ran into a problem where the wifi card of my Raspberry Pi 3 can not be initialized after I've executed mkinitrd.
I've used the latest JeOS Leap42.2 image.
openSUSE-Leap42.2-ARM-JeOS-raspberrypi3.aarch64-2017.02.02-Build1.5.raw.xz
When I start the image the WiFi card will be loaded without any problems.
brcmfmac: brcmf_sdio_drivestrengthinit: No SDIO Drive strength init done for chip 43430 rev 1 pmurev 24 brcmfmac: brcmf_c_preinit_dcmds: Firmware version = wl0: May 27 2016 00:13:38 version 7.45.41.26 (r640327) FWID 01-df77e4a7 brcmfmac: brcmf_cfg80211_reg_notifier: not a ISO3166 code
After a simple mkinitrd the module cannot be loaded anymore.
brcmfmac_sdio: probe of mmc1:0001:1 failed with error -110 brcmfmac_sdio: probe of mmc1:0001:2 failed with error -110
I couldn't find out so far what caused this problem.
Anyone any hint/idea?
Ciao, Alex~
Hi I just followed the steps in the following archive message on a Leap 42.2 JeOS install (except I just used mkinitrd) https://lists.opensuse.org/opensuse-arm/2016-11/msg00018.html
Wireless is up.
Hi (again) One other thought, is the time/date configured? I've seen some funnies if it's not set, prefer to use ntp... -- Cheers Malcolm °¿° SUSE Knowledge Partner (Linux Counter #276890) openSUSE Leap 42.1|GNOME 3.16.2|4.1.36-44-default up 4 days 21:00, 3 users, load average: 0.17, 0.09, 0.12 CPU AMD Athlon(tm) II X4 635 @ 2.90GHz | GPU Nvidia GeForce 8800 GT -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org