Takeyama-san
Thank you for your information below.
I could resolve my problem.
Regards.
Ryo
On 2016/06/08 23:40, "Fuminobu TAKEYAMA"
You need to pass frame-buffer width and height to kernel cmdline
The following thread helps you: http://lists.opensuse.org/opensuse-arm/2016-03/msg00157.html
Here is also how to specify resolution and write to boot loader script: https://en.opensuse.org/HCL:Raspberry_Pi#Known_Issues_with_Tumbleweed_.28u pstream.29
Fuminobu TAKEYAMA
On 2016/06/08 18:48, 村川 了 wrote:
Hi
I installed openSUSE-Tumbleweed-ARM-LXQT-raspberrypi3.armv7l.raw on my Pi3. System works well. I connect this Pi3 to Panasonic LCD display (1960x1024). But the resolution is 800x400. I run display settings. But I can’t change the resolution. So could you tell me how to change the display resolution?
Regards.
Ryo
-- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org
-- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org