Mailinglist Archive: opensuse-arm (69 mails)

["Joop Boonen" <joop.boonen@xxxxxxxxxx>]

On Mon, November 14, 2011 1:02 pm, Joop Boonen wrote:
> On Mon, November 14, 2011 10:09 am, Andrew Wafaa wrote:
> > On Mon, 2011-11-14 at 09:14 +0100, Joop Boonen wrote:
> > > I didn't get to this was working on the kernel. Hopefully I can fix
> this issues with this one soon. I have an usb issue, that I need to
> fix. ( home:worldcitizen:armv7l kernel-omap4panda )
> > >
> >
> > I've submitted a patch to the kernel team that builds the following
> > kernels for 3.1: omap2plus, imx51 and tegra. Let me know if you need
> > anything from that to help with u-boot etc.
>
> u-boot and x-boot are not dependent on the kernel as far as I know.
>
> Does this patch give a prompt in the tty's?
> I've build the terminal according to http://elinux.org/PandaBoard this
> didn't give a prompt in the tty.
> For me the only working kernel is the one according to:
> http://wiki.meego.com/ARM/OMAP4_Panda#kernel
>
> > > After that I'll start working on kiwi.
> > >
> > > > > > Hopefully
> > > > > > the current build will succeed.
> > > > > >
> > > > > > If someone wants to help, could someone package u-boot (the arm
> > > boot
> > > > > > loader) ?
> > > > > > I suppose it will be a pre-requirement for the kiwi support.
> > > > >
> > > > > U-boot has been build for the pandaboard. I used the meego version
> > > as
> > > a
> > > > > base. It still needs a bit of tuning.
> > > > > The package can be found here: home:worldcitizen:armv7l
> > > > > u-boot-omap4panda
> > > >
> > > > please look for a devel project and submit to factory.
> > > I've submitted both x-loader-omap4panda and u-boot-omap4panda to
> Base:System . (request id 91227 and request id 91228)
> > > I've tested both of them on my PandaBoard.
> >
> > Would it be possible to re-name the packages to fall in line with the
> kernels being built? For OMAP it is omap2plus, as per the config. This
> should support all omap2plus devices, including the Beagle and Panda.
>
> That's OK. I can rename it. I won't be able to test it on a BeagleBoard.

I've just check it out. The PandaBoard and the Beagle board use different
configurations. This is to be expected as the hardware around the OMAP is
different.
So I cant change the name. I can build the BeagleBoard version.

> > Regards,
> >
> > Andy
> >
> > --
> > Andrew Wafaa
> > IRC: FunkyPenguin
> > GPG: 0x3A36312F
Regards,

Joop.


-- 
To unsubscribe, e-mail: opensuse-arm+unsubscribe@xxxxxxxxxxxx
To contact the owner, e-mail: opensuse-arm+owner@xxxxxxxxxxxx