Mailinglist Archive: opensuse-amd64 (194 mails)

< Previous Next >
Re: [suse-amd64] 9.3 with 8GB ram
  • From: Mark Horton <mark@xxxxxxxxxxxx>
  • Date: Sat, 23 Apr 2005 22:51:17 +0000 (UTC)
  • Message-id: <426ACFF7.5050703@xxxxxxxxxxxx>
Andi Kleen wrote:
On Sat, Apr 23, 2005 at 12:15:01AM -0400, Mark Horton wrote:

I just received 9.3 today and installed it on my workstation. I had to add 'mem=2000m' to the kernel boot options get it to boot up after the install. Is this a known problem?


No. Can you post a serial console log of a bootup without the option?

-Andi


I got a serial cable hooked up and the output is below.

Mark


Bootdata ok (command line is root=/dev/hda4 vga=0x317 selinux=0 console=tty0 desktop elevator=as splash=verbose console=tty0 console=ttyS0,115200)
Linux version 2.6.11.4-20a-smp (geeko@buildhost) (gcc version 3.3.5 20050117 (prerelease) (SUSE Linux)) #1 SMP Wed Mar 23 21:52:37 UTC 2005
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 00000000bfff0000 (usable)
BIOS-e820: 00000000bfff0000 - 00000000bffff000 (ACPI data)
BIOS-e820: 00000000bffff000 - 00000000c0000000 (ACPI NVS)
BIOS-e820: 00000000ff780000 - 0000000100000000 (reserved)
BIOS-e820: 0000000100000000 - 0000000240000000 (usable)
SRAT: PXM 0 -> APIC 0 -> Node 0
SRAT: PXM 1 -> APIC 1 -> Node 1
SRAT: Node 0 PXM 0 100000-bfffffff
SRAT: Node 1 PXM 1 140000000-23fffffff
SRAT: Node 0 PXM 0 0-bfffffff
node 1 shift 24 addr 140000000 conflict 0
node 1 shift 25 addr 1fe000000 conflict 0
Bootmem setup node 0 0000000000000000-00000000bfffffff
Bootmem setup node 1 0000000140000000-000000023fffffff
ACPI: LAPIC (acpi_id[0x01] lapic_id[0x00] enabled)
Processor #0 15:5 APIC version 16
ACPI: LAPIC (acpi_id[0x02] lapic_id[0x01] enabled)
Processor #1 15:5 APIC version 16
ACPI: LAPIC (acpi_id[0x03] lapic_id[0x82] disabled)
ACPI: LAPIC (acpi_id[0x04] lapic_id[0x83] disabled)
ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0])
IOAPIC[0]: apic_id 2, version 17, address 0xfec00000, GSI 0-23
ACPI: IOAPIC (id[0x03] address[0xfa9fe000] gsi_base[24])
IOAPIC[1]: apic_id 3, version 17, address 0xfa9fe000, GSI 24-27
ACPI: IOAPIC (id[0x04] address[0xfa9ff000] gsi_base[28])
IOAPIC[2]: apic_id 4, version 17, address 0xfa9ff000, GSI 28-31
ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
Setting APIC routing to flat
ACPI: HPET id: 0x102282a0 base: 0xfec01000
Using ACPI (MADT) for SMP configuration information
Checking aperture...
CPU 0: aperture @ f0000000 size 128 MB
CPU 1: aperture @ f0000000 size 128 MB
Built 2 zonelists
Kernel command line: root=/dev/hda4 vga=0x317 selinux=0 console=tty0 desktop elevator=as splash=verbose console=tty0 console=ttyS0,115200
bootsplash: verbose mode.
Initializing CPU#0
PID hash table entries: 4096 (order: 12, 131072 bytes)
time.c: Using 14.318180 MHz HPET timer.
time.c: Detected 2193.023 MHz processor.
Console: colour dummy device 80x25
Dentry cache hash table entries: 1048576 (order: 11, 8388608 bytes)
Inode-cache hash table entries: 524288 (order: 10, 4194304 bytes)
Memory: 7219276k/9437184k available (2280k kernel code, 0k reserved, 1179k data, 212k init)
Security Framework v1.0.0 initialized
SELinux: Disabled at boot.
Mount-cache hash table entries: 256 (order: 0, 4096 bytes)
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 1024K (64 bytes/line)
CPU 0(1) -> Node 0
checking if image is initramfs... it is
ACPI: Looking for DSDT in initrd... not found!
not found!
Using local APIC NMI watchdog using perfctr0
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 1024K (64 bytes/line)
CPU 0(1) -> Node 0
CPU0: AMD Opteron(tm) Processor 248 stepping 08
per-CPU timeslice cutoff: 1023.71 usecs.
task migration cache decay timeout: 2 msecs.
Booting processor 1/1 rip 6000 rsp ffff810144537f58
Initializing CPU#1
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 1024K (64 bytes/line)
CPU 1(1) -> Node 1
AMD Opteron(tm) Processor 248 stepping 08
Total of 2 processors activated (8699.90 BogoMIPS).
Using local APIC timer interrupts.
Detected 12.460 MHz APIC timer.
checking TSC synchronization across 2 CPUs: passed.
time.c: Using HPET based timekeeping.
Brought up 2 CPUs
NET: Registered protocol family 16
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20050211
ACPI: Interpreter enabled
ACPI: Using IOAPIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
Unable to handle kernel paging request at 0000000000002730 RIP:
<ffffffff80120ed3>{iounmap+323}
PGD 0
Oops: 0000 [1] SMP
CPU 1
Modules linked in:
Pid: 1, comm: swapper Not tainted 2.6.11.4-20a-smp
RIP: 0010:[<ffffffff80120ed3>] <ffffffff80120ed3>{iounmap+323}
RSP: 0018:ffff810144471be8 EFLAGS: 00010293
RAX: ffff8100fa8fd000 RBX: ffff810144541bc0 RCX: 000000000000001a
RDX: ffffffff7fffffff RSI: 0000000000002000 RDI: 00000000fa8fd000
RBP: ffffc20000004000 R08: 0000000000000000 R09: 0000000000000000
R10: 0000000000000000 R11: ffffffff80470ff8 R12: ffffffff803d8670
R13: ffff81014451da00 R14: ffff810144550800 R15: ffff81014451de00
FS: 0000000000000000(0000) GS:ffffffff804e3300(0000) knlGS:0000000000000000
CS: 0010 DS: 0018 ES: 0018 CR0: 000000008005003b
CR2: 0000000000002730 CR3: 00000000bfe80000 CR4: 00000000000006e0
Process swapper (pid: 1, threadinfo ffff810144470000, task ffff8100bffc3750)
Stack: ffffffff803d8670 ffffc20000004000 00000000000001ea ffffffff8022dc77
0000000000000000 0000000000000000 ffff81014451da00 ffffffff803d82a0
ffff810144550800 ffffffff803d8670
Call Trace:<ffffffff8022dc77>{quirk_usb_early_handoff+871} <ffffffff8022d008>{pci_fixup_device+136}
<ffffffff8022b53c>{pci_scan_single_device+1084} <ffffffff8022b59e>{pci_scan_slot+30}
<ffffffff8022bc0f>{pci_scan_child_bus+31} <ffffffff8022baa6>{pci_scan_bridge+390}
<ffffffff8022bc5b>{pci_scan_child_bus+107} <ffffffff8022be09>{pci_scan_bus_parented+377}
<ffffffff80261c6a>{acpi_pci_root_add+650} <ffffffff80263f63>{acpi_bus_driver_init+52}
<ffffffff80264df7>{acpi_bus_add+2204} <ffffffff80264f70>{acpi_bus_scan+271}
<ffffffff8050b95f>{acpi_scan_init+166} <ffffffff8010c232>{init+482}
<ffffffff8010f6bb>{child_rip+8} <ffffffff8010c050>{init+0}
<ffffffff8010f6b3>{child_rip+0}

Code: 49 8b 88 30 27 00 00 76 2a 48 b8 00 00 00 80 00 81 ff ff 48
RIP <ffffffff80120ed3>{iounmap+323} RSP <ffff810144471be8>
CR2: 0000000000002730
<0>Kernel panic - not syncing: Attempted to kill init!


< Previous Next >
Follow Ups
References