El dt. 09 de 02 de 2021 a les 14:11 +0100, en/na Martin Willisegger va escriure:
Hello Martin,
Uyuni is also a Salt Master as the Salt configuration management stack is integrated in it.
Salt has several components, one of them is called "pillar", it can do exactly what you are asking. Have a look at:
After you have pillar values declared, you can reference them from states that will apply configuration (highstate) to your systems.
Templating is very useful, by using jinja in your states you can consume your key-value pairs to fill configuration declarations:
At last you can assign these states to all systems or to systems that belongs to some group or on individual systems.
These are my two cents, hope this helps you.
regards,
Jordi Bruguera <hola@jorx.pro>
Systems Architect.
Hello List
Suppose I were to manage 100 servers with Uyuni and had to roll out a
system configuration that looked like this:
parameterA=value1
parameterB=value2
parameterC=value3
parameterD=value4
On most servers it would look the same, but some servers would need e.g.
parameterB=value5
parameterD=value6
Other servers would need an additional line:
parameterE=value7
And other servers would not need a single parameter
#parameterA=value1
Can this requirement be easily managed and clearly displayed via Uyuni's
configuration management, and can it be adapted at any time for further
requirements or omitted exceptions? Would it only work with fully
supported clients (SLES), or also with openSuSE/Uyuni clients via salt?
Best regards
Martin