Hi, I am using eth1-pcmcia by taking "kernel" instead of "ëxternal" With orinoco.o Hardware is all detected correctly as far as I can tell. In /etc/sysconfig/wireless/ I put the WEP key something like "1234-5678-9012-3456-78" to enable 126-bit WEP. This does not match exactly with the sixteen digit which SuSE seems to favor. I do not know. However, putting "öff" did not work either for an WEP disabled wireless router. I think I screwed with the DHCP. Anyway. please help after examining the following I would appreciate it greatly if any one can lead me to the right direction. Thank you. Hugh ======================= $ ifconfig eth1 Link encap:Ethernet HWaddr 00:04:5A:0D:DA:21 UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:24 errors:12 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:15456 (15.0 Kb) Interrupt:11 Base address:0x100 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:68 errors:0 dropped:0 overruns:0 frame:0 TX packets:68 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:4927 (4.8 Kb) TX bytes:4927 (4.8 Kb) $ iwconfig eth1 IEEE 802.11-DS ESSID:"Song" Nickname:"rodolfo" Mode:Managed Frequency:2.437GHz Access Point: 00:0D:88:98:1E:4A Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3 Retry min limit:8 RTS thr:off Fragment thr:off Encryption key:1957-1987-1991-4256-2109-0212-04 Security mode:open Power Management:off Link Quality:65/92 Signal level:-37 dBm Noise level:-149 dBm Rx invalid nwid:0 Rx invalid crypt:443 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 Here is the /var/log/messages after I failed with $ ifup eth1 ---------------------------------------------------- Feb 8 03:57:50 rodolfo dhcpcd[9748]: terminating on signal 15 Feb 8 03:57:50 rodolfo dhcpcd-hook: State: down. Leaseinfo: <none given> Feb 8 03:57:50 rodolfo dhcpcd-hook: Skipping 'ifdown $INTERFACE -o dhcp' call Feb 8 03:57:56 rodolfo kernel: eth1: Error -110 setting multicast list. Feb 8 03:57:56 rodolfo kernel: eth1: Error -110 setting multicast list. Feb 8 03:57:56 rodolfo dhcpcd[11579]: broadcasting DHCP_REQUEST for 192.168.0.100 Feb 8 03:57:56 rodolfo kernel: eth1: New link status: Connected (0001) Feb 8 03:58:06 rodolfo dhcpcd[11579]: timed out waiting for DHCP_ACK response Feb 8 03:58:06 rodolfo dhcpcd[11579]: broadcasting DHCP_DISCOVER
participants (1)
-
Hugh