I have problems getting a new ethernet card working on one of my machines, It is a Jensen card with a Realtek driver(rtl8139.o). When I use Yast2 to set up my card i get this error message at the end: 'These errors occured during saving configuration: Device eth0 is not running'. I have installed the driver which was included with the card. Some excerpts from logs: Boot.msg: Setting up network device eth0 modprobe: modprobe: Can't locate module eth0 SIOCSIFADDR: No such device modprobe: modprobe: Can't locate module eth0 eth0: unknown interface: No such device modprobe: modprobe: Can't locate module eth0 SIOCSIFBRDADDR: No such device modprobe: modprobe: Can't locate module eth0 eth0: unknown interface: No such device modprobe: modprobe: Can't locate module eth0 SIOCSIFNETMASK: No such device done Setting up routing (using /etc/route.conf) done lspci: 00:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139 (rev 10) Subsystem: Realtek Semiconductor Co., Ltd. RT8139 Flags: medium devsel I/O ports at f800 [disabled] [size=256] Memory at fedffc00 (32-bit, non-prefetchable) [disabled] [size=256] Capabilities: [50] Power Management version 2 --- Anyone knows what is wrong? Any help are appreciated. Jostein