Hardware wizard problems
I am having problems with the hardware detection wizard being displayed after users login. Scenario is as follows: The machine has been installed, configured and usable by all users. Now, what happens is one a user logs into the machine the hardware wizard appears and asks you to install and configure the NIC, Audio & HDD even though they are currently configured. Does anyone know where these settings are stored so I may manually inspect them or perhaps provide some good resources on either disabling the h/w wizard etc.? Thanks in advance, -- Jason Gerfen jason.gerfen@scl.utah.edu "And remember... If the ladies don't find you handsome, they should at least find you handy..." ~The Red Green show
On 16.02.05,13:20, Jason Gerfen wrote:
I am having problems with the hardware detection wizard being displayed after users login.
Scenario is as follows: The machine has been installed, configured and usable by all users. Now, what happens is one a user logs into the machine the hardware wizard appears and asks you to install and configure the NIC, Audio & HDD even though they are currently configured. Does anyone know where these settings are stored so I may manually inspect them or perhaps provide some good resources on either disabling the h/w wizard etc.? Thanks in advance,
--
Have you run the online update to check if an update to this has been
made?
Also check the settings under hardware in sysconfig(run 'yast
sysconfig').
- Jostein
--
Jostein Berntsen
participants (2)
-
Jason Gerfen
-
Jostein Berntsen