I used YaST2 to configure 2 network interfaces under SuSE 10.0, to be functioning as an Internet Gateway for my LAN. I enabled IP Forwarding, checked the IP addresses and the Firewall settings, but it will NOT do the NAT job! Please Help!!?? Regards, gerold@sicon-sr.com -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
On Monday 03 July 2006 01:07, Gerold van Dijk wrote:
I used YaST2 to configure 2 network interfaces under SuSE 10.0, to be functioning as an Internet Gateway for my LAN.
I enabled IP Forwarding, checked the IP addresses and the Firewall settings, but it will NOT do the NAT job!
Please Help!!??
Regards,
gerold@sicon-sr.com
Had the same problem. Not much info there but if you are using a router connected to the Internet like a broadband connection, then you must NAT the router address to your lan router box first. Like our router is 192,168.0.254. We NAT that (choose your flavour of ports) to 192.168.0.1 and then to our lan at 192.168.1.1 etc. etc. Steve. -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
On 02/07/06 17:07, Gerold van Dijk wrote:
I used YaST2 to configure 2 network interfaces under SuSE 10.0, to be functioning as an Internet Gateway for my LAN.
I enabled IP Forwarding, checked the IP addresses and the Firewall settings, but it will NOT do the NAT job!
It doesn't work because you are not forwarding, you want to masquerade the internal network. Turn on FW_ROUTE and FW_MASQUERADE, set FW_MASQ_DEV (usually this will be set to $FW_DEV_EXT), and specify the subnets that are to be masqueraded in FW_MASQ_NETS, eg 192.168.1.0/24. -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
On 02/07/06 17:07, Gerold van Dijk wrote:
I used YaST2 to configure 2 network interfaces under SuSE 10.0, to be functioning as an Internet Gateway for my LAN.
I enabled IP Forwarding, checked the IP addresses and the Firewall settings, but it will NOT do the NAT job!
Please Help!!??
Regards,
gerold@sicon-sr.com
PS, turn IP forwarding *off*, unless you really are forwarding something, which is rather unlikely. -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
participants (3)
-
Darryl Gregorash -
Gerold van Dijk -
steve