From: "Per Jessen"

david rankin wrote:

...

This is strange. What is the eth0 ADMtek from dmesg below?

That's your Linksys card. It has a Comet chip from ADMTek, which I believe is supported by the tulip driver. I'm not sure where your eth1 comes from, but might it just possibly be related to your IP6 over IP4 tunnel?

OK, what is the best way to disable IP6 in SuSE10. I'll give that a try....

...

Linux Tulip driver version 1.1.13-NAPI (May 11, 2002) ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:00:0f.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11 tulip0: MII transceiver #1 config 1000 status 786d advertising 05e1. eth0: ADMtek Comet rev 17 at 0001ec00, 00:04:5A:87:C8:43, IRQ 11. NET: Registered protocol family 10 Disabled Privacy Extensions on device c036b920(lo) IPv6 over IPv4 tunneling driver ACPI: Power Button (FF) [PWRF] ACPI: Power Button (CM) [PWRB] ACPI: Sleep Button (CM) [SLPB] 0000:00:0f.0: tulip_stop_rxtx() failed eth1: Setting full-duplex based on MII#1 link partner capability of 45e1.

-- David C. Rankin, J.D., P.E. RANKIN LAW FIRM, PLLC 510 Ochiltree Street Nacogdoches, Texas 75961 (936) 715-9333 (936) 715-9339 fax www.rankinlawfirm.com --