Hello, Page http://wiki.x.org/wiki/RadeonFeature says that status of TV-out is unknown for RV620. I tried it. Driver can not recognize card (HD3450), but recognizes chipset (RV620). Both TV and VGA attached to the same DACB and only VGA works. If I add my card info into rhdCards array, have I chance to set up my TV? Or may be I should try to change xorg.conf somehow... Here most impotant parts of xorg log, full log attached. (I tried 1.2.1 and git versions) (II) RADEONHD(0): Unknown card detected: 0x95C5:0x1787:0x2252. If - and only if - your card does not work or does not work optimally please contact radeonhd@opensuse.org to help rectify this. Use the subject: 0x95C5:0x1787:0x2252: <name of board> and *please* describe the problems you are seeing in your message. (II) RADEONHD(0): Connector[0] {RHD_CONNECTOR_TV, "7PIN_DIN TV1 CV", RHD_DDC_0, RHD_HPD_NONE, { RHD_OUTPUT_DACB, RHD_OUTPUT_NONE } } (II) RADEONHD(0): Connector[1] {RHD_CONNECTOR_VGA, "VGA CRT2", RHD_DDC_1, RHD_HPD_NONE, { RHD_OUTPUT_DACB, RHD_OUTPUT_NONE } } (II) RADEONHD(0): Connector[2] {RHD_CONNECTOR_DVI, "DUAL_LINK_DVI_I CRT1 DFP1", RHD_DDC_0, RHD_HPD_0, { RHD_OUTPUT_KLDSKP_LVTMA, RHD_OUTPUT_DACA } } (--) RADEONHD(0): Attaching Output DAC B to Connector TV 7PIN_DIN (--) RADEONHD(0): Attaching Output DAC B to Connector VGA 1 (--) RADEONHD(0): Attaching Output UNIPHY_KLDSKP_LVTMA to Connector DVI-I 1 (--) RADEONHD(0): Attaching Output DAC A to Connector DVI-I 1 (II) RADEONHD(0): RandR: Adding RRoutput TV_7PIN_DIN for Output DAC B (II) RADEONHD(0): RandR: Adding RRoutput VGA_1 for Output DAC B (II) RADEONHD(0): RandR: Adding RRoutput DVI-I_1/digital for Output UNIPHY_KLDSKP_LVTMA (II) RADEONHD(0): RandR: Adding RRoutput DVI-I_1/analog for Output DAC A (II) RADEONHD(0): Output TV_7PIN_DIN has no monitor section (II) RADEONHD(0): Output VGA_1 has no monitor section (II) RADEONHD(0): Output DVI-I_1/digital has no monitor section (II) RADEONHD(0): Output DVI-I_1/analog has no monitor section (II) RADEONHD(0): DAC B: Sensed Output: TV_COMPOSITE (WW) RADEONHD(0): No monitor size info, assuming 96dpi. (II) RADEONHD(0): DAC B: Sensed Output: VGA .... (II) RADEONHD(0): Output TV_7PIN_DIN connected (II) RADEONHD(0): Output VGA_1 connected (II) RADEONHD(0): Output DVI-I_1/digital disconnected (II) RADEONHD(0): Output DVI-I_1/analog disconnected (EE) RADEONHD(0): Output TV_7PIN_DIN enabled but has no modes (II) RADEONHD(0): Output VGA_1 using initial mode 1280x1024