Re: [suse-ppc] RS600 439 + problem with graphical card
El mar, 13-09-2005 a las 19:08 +0200, Olaf Hering escribió:
On Tue, Sep 13, jjcp@ono.com wrote:
Graphical card = GXT550P
I have tried with "boot cdrom:,zimage root=/dev/cdrom load_ramdisk=1 console=ttyS0,9600
Just 'boot cdrom' will do it, if the CD is ok. There is CD1/boot/zImage.prep.initrd, this is the bootfile. You can load it also via TFTP, or from an existing Linux installation.
ok, but my problem is not that could not start from cdrom, but as soon as it loads the kernel, the message goes out for me. "You may not see any kernel console output, use a serial console on com1 in this case" Thank you for answering
On Wed, Sep 14, jjcp@ono.com wrote:
El mar, 13-09-2005 a las 19:08 +0200, Olaf Hering escribió:
On Tue, Sep 13, jjcp@ono.com wrote:
Graphical card = GXT550P
I have tried with "boot cdrom:,zimage root=/dev/cdrom load_ramdisk=1 console=ttyS0,9600
Just 'boot cdrom' will do it, if the CD is ok. There is CD1/boot/zImage.prep.initrd, this is the bootfile. You can load it also via TFTP, or from an existing Linux installation.
ok,
but my problem is not that could not start from cdrom, but as soon as it loads the kernel, the message goes out for me. "You may not see any kernel console output, use a serial console on com1 in this case"
Yes, there is a hint right before these lines. Add 'console=ttyS0' to the kernel command line, within 10 seconds.
participants (2)
-
jjcp＠ono.com -
Olaf Hering