In Gkrellm I monitor the teperatures and fan speeds on a regular base, due to the high daily temperatures. Up to 12.2 I was able to have the system and CPU temperature and all three temps from the harddisks. Two fan speeds were also shown. Due to an acpi driver problem I have to add "acpi_enforce_resources=lax" in the bootsequence. Worked like a charm. In 12.3 though the CPU, system temp and fans are not shown any more. And when I remove "acpi_enforce_resources=lax" from the boot sequence also my harddisk temperatures vanish. According to the sensors-detect my temp chip is a Winbond A83697HF/F/HG on the ISA bus at 0x290. What has changed since 12.2 that causes the noshow and is there a solution? Is my problem Suse specific or should I ask de Gkrellm people? Sensors shows everything. # sensors acpitz-virtual-0 Adapter: Virtual device temp1: +18.5°C (crit = +75.0°C) w83697hf-isa-0290 Adapter: ISA adapter in0: +1.47 V (min = +3.97 V, max = +0.22 V) ALARM in2: +3.30 V (min = +0.91 V, max = +1.47 V) ALARM in3: +2.96 V (min = +0.11 V, max = +1.12 V) ALARM in4: +3.15 V (min = +1.15 V, max = +2.72 V) ALARM in5: +0.61 V (min = +3.84 V, max = +2.38 V) ALARM in6: +3.57 V (min = +3.46 V, max = +0.35 V) ALARM in7: +3.23 V (min = +0.13 V, max = +3.01 V) ALARM in8: +3.12 V (min = +1.57 V, max = +1.79 V) ALARM fan1: 2450 RPM (min = 45000 RPM, div = 2) ALARM fan2: 3214 RPM (min = 27000 RPM, div = 2) ALARM temp1: +36.0°C (high = -95.0°C, hyst = +47.0°C) sensor = thermistor temp2: +18.5°C (high = +70.0°C, hyst = +65.0°C) sensor = CPU diode beep_enable: enabled -- Linux User 183145 using KDE4 on a Pentium IV , powered by openSUSE 12.3 Milestone 1 (i586) Kernel: 3.6.3-1-default KDE Development Platform: 4.9.80) 14:36pm up 0:08, 3 users, load average: 1.96, 4.79, 2.76 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org