On Thu, Jun 5, 2008 at 2:24 PM, Marc Ensenbach wrote:

during the installation of RC1 I intended to change the software selection. Entering the dialog I found that disk usage is always displayed to be 0%, even after checking additional patterns. Is this a known issue?

I don't see an open bug on this issue. However, I am not an expert. I would wait a few days to see if anyone else responds and then open a bug report at bugzilla.novell.com. Mike --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org

Am Donnerstag, 5. Juni 2008 schrieb Marc Ensenbach:

Hello,

during the installation of RC1 I intended to change the software selection. Entering the dialog I found that disk usage is always displayed to be 0%, even after checking additional patterns. Is this a known issue?

bug 395051? Greetings, Stephan --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org

Am Donnerstag, 5. Juni 2008 schrieb Marc Ensenbach:

Furthermore, I noticed that after clicking on additional patterns it takes quite some time until finally the checkmark is displayed. I find this lag somewhat annoying, since at first I thought that my click had not been recognised correctly.

Yes, this effect is highly disturbing. On the first sight, I blamed it on the install time environment, but the delay persists also for any call to yast2 sw_single later on. Anybody care to explain the technical reasons (simplified) for this annoyance? Pete --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org