https://bugzilla.novell.com/show_bug.cgi?id=231172 Summary: YaST not able to read partitions on i2o-Device Product: openSUSE 10.2 Version: Final Platform: All OS/Version: Other Status: NEW Severity: Critical Priority: P5 - None Component: YaST2 AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: grupp@elektronikschule.de QAContact: jsrain@novell.com While trying to install openSUSE 10.2 over a previous installation with openSUSE 10.1 YaST reported, that it is not able to read or manipulate the partition table of my i2o-harddrive (RAID-System from Fujitsu-Siemens). I had to delete the disk label and all informations about the previous partitions was lost. While I accepted this on my test system this is not acceptable for a production system. Now, after installing openSUSE 10.2, I realizied that YaST is not able to read the partition table of the system installed by the same YaST!?? YaST gives the output that it is not possible to read the partition with "parted". After accepting this message I am only shown the disk with no partitions at all! When using "parted" in a shell I get the following informations (with shows that parted seems to read the informations quite well): (parted) print Disk /dev/i2o/hda: 146GB Sector size (logical/physical): 512B/512B Partition Table: msdos Number Start End Size Type File system Flags 1 32.3kB 21.5GB 21.5GB primary ext3 boot, , , , , , , , , type=83, , 2 21.5GB 43.0GB 21.5GB primary ext3 , , , , , , , , , type=83, , 3 43.0GB 46.2GB 3224MB primary linux-swap , , , , , , , , , type=82, , 4 46.2GB 146GB 99.4GB extended , , , , , , lba, , , type=0f, , 5 46.2GB 99.9GB 53.7GB logical ext3 , , , , , , , , , type=83, , Is it possible to fix this? Would be great! Andreas -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.