Comment # 46 on bug 926053 from Thomas Blume

(In reply to Philippe Cond� from comment #45)
> Hello,
> 
> I updated the firmware op the raid controller to the last version (6.34) but
> this doesn't help.
> 
> I have seen that I didn't read carefully your last comment and was not
> looking in the correct library.
> 
> I have then changed the file /lib/udev/rules.d/58-scsi-sgr_symlink.rules 
> I commented first the line
> ENV{SCSI_IDENT_SERIAL}=="?*", ENV{DEVTYPE}=="disk",
> SYMLINK+="disk/by-id/scsi-
> S$env{SCSI_VENDOR}_$env{SCSI_MODEL}_$env{SCSI_IDENT_SERIAL}"
>  and rebooted the system but some error messages were still present  
> 
> I commented then also the next line:
> ENV{SCSI_IDENT_SERIAL}=="?*", ENV{DEVTYPE}=="partition",
> SYMLINK+="disk/by-id/scsi-
> S$env{SCSI_VENDOR}_$env{SCSI_MODEL}_$env{SCSI_IDENT_SERIAL}-part%n"
> 
> After reboot the error messages have disappear. 

Ok

> One question: are there some drawback with these settings?
> 

It would only be problematic if something would be using these symlinks (for
example mounts or lvm).
But per default they are not used, so you can savely omit them.