openSUSE-Factory-ARM-JeOS-cubieboard.armv7l-1.12.1-Build269.1.raw.xz The DPMI output is not activated when a VGA monitor is connected with a DPMI/VGA adapter and the cubieboard is powered up. Guessing, something doesn't wait long enough for the adapter to respond. Sorry I can't imagine too many cubieboards on DPMI monitors, but retired VGA stuff is plentiful. ;-) The adapters are 10 bucks. U-Boot SPL 2015.04-rc3 (Mar 09 2015 - 21:02:35) DRAM: 1024 MiB CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2 U-Boot 2015.04-rc3 (Mar 09 2015 - 21:02:35) Allwinner Technology CPU: Allwinner A10 (SUN4I) I2C: ready DRAM: 1 GiB MMC: SUNXI SD/MMC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial When the system is rebooted by command (from Linux, Android), the DPMI output is activated: HDMI connected: Setting up a 1280x1024 hdmi console In: serial Out: vga Err: vga There is no reset button on board, so reset is with the power cable. Just as well I'm planning to use this headless... Volker -- Volker Kuhlmann http://volker.top.geek.nz/ Please do not CC list postings to me. -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org