On 30/08/2019 19:43, Frank Kunz wrote:

Am 29.08.19 um 10:18 schrieb Guillaume Gardet:

...

Hi,

...

-----Original Message----- From: Frank Kunz Sent: 15 August 2019 21:39 To: opensuse-arm@opensuse.org Subject: [opensuse-arm] RFC Espressobin install procedure

Hello,

I prepared an install procedure for the espressobin board: https://en.opensuse.org/HCL:EspressoBin

Thanks for your contribution!

...

The procedure became quite complex and I want to ask if there is a simpler approach to get opensuse arm64 efi working?

Maybe you could use the ISO image to run the installer?

It seems that the install ISO (I used tumbleweed net install for a quick test) is missing a proper device tree for my board. There are device trees included in the ISO, but only for some Raspberry-Pi models, no other boards. Is there a generic way to get the needed device tree into it?

We expect the boot firmware (e.g. u-boot) to pass a valid device-tree. RPi is the exception we don't want to deal with device tree blobs but await that the board manufacturer provides a working one. So no, there is no generic way to get that done, sorry. Regards, Matthias

Br, Frank

...

Guillaume

...

Br, Frank -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org

IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium. Thank you. N�����r��y隊Z)z{.�櫛맲��r��z�^�ˬz��N�(�֜��^� ޭ隊Z)z{.�櫛�0�����Ǩrg==

N�����r��y隊Z)z{.�櫛맲��r��z�^�ˬz��N�(�֜��^� ޭ隊Z)z{.�櫛�0�����Ǩ�