Re: [suse-amd64] Suse9.1 Failed Install on SK8N
All,
Thanks for the help. I may try that (although I have a number of images on my /boot drive - I'd hate to lose them). I was hoping to have the Suse boot info installed on a floppy disk, and I could just copy the info over from floppy to /boot without disturbing my current configuration.
Does anyone know why the install program can't find /dev/fd0? Does Suse 9.1 have problems accessing /dev/fd0?
Thanks again,
Michael
-----Original Message-----
From: �rn Hansen
1) Before installing SuSE, create a mandrake boot floppy for your current settings.
2) Install SuSE. This, of course overwrites the mandrake boot loader on your hard drive. That is why you created the floppy in step 1.
3) After SuSE is installed, boot to mandrake from your floppy. Update the mandrake boot loader by adding a new entry for SuSE, and write it to your hard drive. This will overwrite the bootloader installed by SuSE in step 2, but will give you back all you had before, and a new entry for SuSE.
Se�n
I think something like the above, should be put in the User manual ... -- Check the List-Unsubscribe header to unsubscribe For additional commands, email: suse-amd64-help@suse.com
On Thu, May 20, 2004 at 03:16:42PM -0400, michael12@mindspring.com wrote:
All,
Thanks for the help. I may try that (although I have a number of images on my /boot drive - I'd hate to lose them). I was hoping to have the Suse boot info installed on a floppy disk, and I could just copy the info over from floppy to /boot without disturbing my current configuration.
Does anyone know why the install program can't find /dev/fd0? Does Suse 9.1 have problems accessing /dev/fd0?
The installation system doesn't have a floppy driver on AMD64. That is why the yast option doesn't work. Once the system is installed and booted the floppy should work. -Andi
participants (2)
-
Andi Kleen
-
michael12@mindspring.com