Mailinglist Archive: opensuse (1632 mails)

[Art Fore <art.fore@xxxxxxxxxxx>]

On Mon, 2007-07-30 at 18:32 +0800, Art Fore wrote:
> A few months ago, I used my HP Scanjet 5300C on Suse 10.2 with no
> problems. Now, it is a hit or miss process, mostly miss.
> 
> I go to Yast, Hardware, Scanner, the scanner was listed using the
> avision driver. I do a test, the test passes.
> 
> Go to OpenOffice Draw, Insert picture, from scanner,then select scanner.
> No scanner shows up.
> 
> Go to Kooka, it also does not find the scanner. Try Xsane, takes about
> 10 minutes to get open, but also cannot find the scanner.
> 
> Kooka did work one time after going to yast and running a test on the
> scanner, but then no more. 
> 
> Nothing shows up in the system log other than where yast installed it
> when I edited the scanner setup with no changes.
> 
> Apparently, one of the upgrades changed something the scanning system
> does not like. Does anyone have any suggestions on this? I checked the
> bugzilla report (https://bugzilla.novell.com/show_bug.cgi?id=141079)
> mentioned in a previous thread, but that does not seem to be quite the
> same.
> 
> System is 64-bit AMD athlon 3200+ with 2 gig of ram.
> 
> Art
> 
Tried this again tonight, did get something different. Kooka found
scanner, but prescan did not work. Xsane comes up with an error that
HewlettPackard:Scanjet5300.drc is not a device-rc-file!!!

Couuld not find any info on this file. Is this the problem? If so, where
does it come from? File is there in proper path, but it is 0 bytes long.

Art

-- 
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx